Aluminum Steering Rack Bushings

These Aluminum Rack Bushings adjust both Ackerman angle and bumpsteer geometry, for better steering response, quicker corner-entry turn-in and more stability. The aluminum bushings replace the factory rubber bushings that mount the steering rack to the front crossmember. By eliminating deflection in the rubber mount, steering response is quicker and more precise. The reversible flange design can be installed two different ways, giving the installer the choice of maintaining factory Ackerman geometry or increasing Ackerman to quicken turn-in and reduce tire scrub in sharp corners. The offset bolt hole in the bushing moves the steering rack up on the crossmember to correct bumpsteer geometry on cars with modified suspensions such as increased caster, X2 balljoints, aftermarket K-members, or other or modifications.

Two different offset heights are available to suit different applications. A .25" offset fits all Mustangs from 1984 1/2 to 2004. A .400" offset is also available for cars requiring larger corrections. The .400" offset fits 1985 to 1995, and will also fit 96-04 applications but may cause interference between the steering rack and the 4.6L oil pan on some cars. Modified suspensions requiring large adjustments with a bumpsteer kit will still benefit from using the offset rack bushings because they will reduce the number of spacers required on the bumpsteer kit. A shorter stack of spacers reduces deflection of the bumpsteer stud, increasing steering precision.

For optimum performance bumpsteer should be checked and adjusted with a bumpsteer kit (adjustable height outer tie rod) after offset rack bushings are installed.


rackbushAlum$39.95
Offset Distance: 
www.realspeedauto.com Ph.631-563-7325

All parts listed are for the Ford Mustang unless otherwise noted.

Copyright 2018 Realspeed Automotive Inc. All rights reserved.